This site makes extensive use of JavaScript.
Please enable JavaScript in your browser.
Classic Theme
Thottbot Theme
Cycle targets
Post Reply
Return to board index
Post by
jtd0060
Hello,
I am looking to make a macro that will target the nearest enemy cast Shadow Word: Pain, then "tab" over to the next target. So that when I press the macro again with will rinse and repeat. I originally was hoping for something that would skip any enemy already under the debuff but the "What macros can and can't do" cleared that up for me, but I can find in the forums (might just be bad at searching) a way to cycle/tab through available hostile targets
I have set something like this up just missing the cycle part as it will keep casting on the same target until it is dead or I switch the target
#showtooltip Shadow Word: Pain
/cleartarget
/targetenemy
/cast Shadow Word: Pain
Post by
jtd0060
#showtooltip Shadow Word: Pain
/cleartarget
/targetenemy
/cast Shadow Word: Pain
/targetenemy
/cast Shadow Word: Pain
This is what I have come up with that is working, adding that 2nd cast seems to keep it from doing a super rapid target switch as it seems without it it will cycle as fast as you can push the button and skips over targets with far more regularity than I would like.
Post Reply
You are not logged in. Please
log in
to post a reply or
register
if you don't already have an account.